Remote Control; General - Dynex DX-50D510NA15 User Manual

Dynex 50" LED TV
Problem Solution
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote control
• Make sure that the power cord
does not work.
• Make sure that there are no
• Point the remote control
• Make sure that the batteries are
• Replace dead batteries with
Trouble
• See instructions and a table of
programming
your existing
universal remote
control.
• Codes are subject to change.
• Replace dead batteries with
• Refer to the User Guide that
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
is plugged into a working
outlet.
obstructions between the
remote control and the remote
control sensor on the front of
the TV.
directly at the remote control
sensor on your TV. For the
location of the remote control
sensor, see "Front" on page 7.
installed correctly. See
"Installing remote control
batteries" on page 33.
new batteries. See "Installing
remote control batteries" on
page 33.
common codes in
"Programming universal remote
controls" on page 64.
For up-to-date codes, go to
www.dynexproducts.com/remotecodes
new batteries. See the User
Guide that accompanied the
universal remote control.
accompanied your universal
remote control and contact the
manufacturer if problems
persist.
www.dynexproducts.com

General

Problem Solution
No power.
• Make sure that the power cord is
plugged into a working outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back
in and turn on your TV.
• Other devices (for example,
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
"No signal"
• Press INPUT and make sure that
error message is
you have selected the correct
displayed.
input for the device or service you
are trying to use.
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
After Auto
• Reception can vary by channel
Channel Search,
depending on the broadcast
there are no
power level of a given station.
channels.
Contact your cable or satellite TV
provider.
• Make sure that the antenna or
cable/satellite box is connected
securely to your TV.
• Try replacing the cable between
the antenna/cable or
cable/satellite box and your TV.
One or more
• Make sure that the channels are
channels do not
not blocked. See
display.
control
• Make sure that the channels are
not hidden. The channel may have
been deleted from the channel
list. You can tune to the channel by
pressing the number buttons or
you can add the channel back to
the channel list. See
channels" on page 56.
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
• If you are using an antenna, the
digital channel signal may be low.
To check the digital channel signal
strength, see
signal
DX-50D510NA15
"Setting parental
levels" on page 48.
"Hiding
"Checking the digital
strength" on page 57.
61