White Knight ECO 43A Instructions For Use Manual

White Knight ECO 43A Instructions For Use Manual

The low carbon dryer

Advertisement

INSTRUCTIONS FOR USE

GB
IMPORTANT
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE.
KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECO 43A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for White Knight ECO 43A

  • Page 1: Instructions For Use

    INSTRUCTIONS FOR USE IMPORTANT PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE. KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.
  • Page 2 SECTION 1: BEFORE USE * Safety warnings * User Information SECTION 2: INSTALLATION * Venting * Prior to Installation * Positioning and Air Supply * Final Installation SECTION 3: TECHNICAL SPECIFICATIONS SECTION 4: CONTROL PANEL * The Timer * Heat Switch * Heater Neon * Start Button SECTION 5: DRYING YOUR LAUNDRY...
  • Page 3 SECTION 1: BEFORE USE * User Information - WARNING: Never stop a tumble dryer before the end of a drying cycle unless all items are quickly removed and spread out so that heat is dissipated. - Clean the lint filter after each drying cycle or the restrictions to airflow will extend drying times and could cause the limit thermostat to stop the burner firing for the remaining part of the drying cycle.
  • Page 4 SECTION 2: INSTALLATION (Cont) Fixed Rear Venting. Venting through a hole at the bottom of the back panel. A vent hose must always be used to vent the warm damp exhaust air. The best solution is to make a permanent connection through either a wall or a window. This is particularly recommended for small, cool rooms and a kit for this purpose is available as an accessory.
  • Page 5 * Final Installation Place the filter in its operating position as shown in the diagram. For cleaning the filter refer to Section 5: Drying your laundry. If you wish to change the side on which your door opens, see Section7 - Door Reversal. Remove any dust by wiping the drum and door with a damp cloth.
  • Page 6 SECTION 5: DRYING YOUR LAUNDRY (CONT) * Drying When starting the dryer for the first time, or starting after temporary disconnection from the gas supply, air in the pipes will prevent ignition. To clear this air, the dryer must be started by turning the timer to a setting of at least 30 minutes.
  • Page 7 SECTION 6: ADDITIONAL INFORMATION * Any Problems? If the clothes are not dry after normal drying time: - Check that you used the correct heater setting. - Check that you have not set the timer within the cool down period. - Check that the lint filter has been cleaned.
  • Page 8 4213 094 79341...

This manual is also suitable for:

Eco 43a

Table of Contents