Subscribe to Our Youtube Channel
Related Manuals for White Knight ECO 83A
Summary of Contents for White Knight ECO 83A
-
Page 1: Instructions For Use
INSTRUCTIONS FOR USE IMPORTANT PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE. KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE. - Page 2 SECTION 1: BEFORE USE * Safety warnings * User Information SECTION 2: INSTALLATION * Venting * Prior to Installation * Positioning and Air Supply * Final Installation SECTION 3: TECHNICAL SPECIFICATIONS SECTION 4: CONTROL PANEL * The Timer * Heat Switch * Heater Neon * Anticrease Neon * Start Button...
-
Page 3: Section 1: Before Use
SECTION 1: BEFORE USE * User Information - WARNING: Never stop a tumble dryer before the end of a drying cycle unless all items are quickly removed and spread out so that heat is dissipated. - Clean the lint filter after each drying cycle or the restrictions to airflow will extend drying times and could cause the limit thermostat to stop the burner firing for the remaining part of the drying cycle. -
Page 4: Section 2: Installation (Cont)
SECTION 2: INSTALLATION (Cont) Fixed Rear Venting. Venting through a hole at the bottom of the back panel. A vent hose must always be used to vent the warm damp exhaust air. The best solution is to make a permanent connection through either a wall or a window. This is particularly recommended for small, cool rooms and a kit for this purpose is available as an accessory. -
Page 5: Section 3: Technical Specifications
If you wish to change the side on which your door opens, see Section7 - Door Reversal. Remove any dust by wiping the drum and door with a damp cloth. Any initial smell of burning will be caused by dust on the heater and will quickly disappear. -
Page 6: Section 5: Drying Your Laundry
SECTION 5: DRYING YOUR LAUNDRY * Before Drying - Check care labels inside the garments CARE LABELS YOU MAY FIND ON YOUR FABRICS SECTION 5: DRYING YOUR LAUNDRY (CONT) * Drying When starting the dryer for the first time, or starting after temporary disconnection from the gas supply, air in the pipes will prevent ignition. -
Page 7: Section 6: Additional Information
- Pull the filter upwards and away from the appliance - Remove any threads or fluff by hand or with a soft brush. - Slide the filter back. - Wash the filter occasionally in detergent solution and with a soft brush to remove small particles. - Page 8 Manufactured by: Crosslee plc. Hipperholme, Halifax, West Yorkshire HX3 8DE 4213 094 79371...
Need help?
Do you have a question about the ECO 83A and is the answer not in the manual?
Questions and answers