2.3
Front of the Printer
2.3.1
Chute ASSY out
Note:
In the following step, lock the chute ASSY out and chute ASSY IN to the printer with
latches A and B.
1) Remove the connectors from the connector bracket on the left side surface of the
printer.
2) Remove 1 screw which is fixing the earth from the left hand side of printer.
3) Shift the harness of the connector removed above from the bottom portion of the
HSG ASSY BIAS on the left side surface of the printer.
4) Remove the connector on the PWBA DRV HBN on the right side surface of the
printer.
5) Remove the harness of harness ASSY DUP from the clamp on drive ASSY main.
6) Carefully remove the cables from the cable quickly taking note of the cable routing.
7) Retake the paper feed roller to raise plate ASSY bottom MSI.
Chute ASSY out
Earth Connector
Fig.4-36
- IV-19 -
Chute ASSY out
Earth Connector
Screw
PWBA DRV HBN
Left side view
Right side view