Pride Mobility Quantum series Owner's Manual page 40

V I I . C A R E
WARNING! Do not mix old and new batteries. Always replace both batteries at the same time.
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III. "Your Power Chair."
3. Remove the foot platform by squeezing the release handles (see figure 29) and lifting the foot platform bracket up and
away from the power base.
4. Disconnect the quick release battery connectors. See figure 29.
5. Remove the batteries.
6. Disconnect the battery harness from each battery.
7. Connect a battery harness to the new front battery according to the battery wiring diagram. See figure 29.
REAR SHROUD FASTENER
(OPPOSITE SIDE NOT SHOWN)
Figure 29. Battery Installation
40
A N D
QUICK RELEASE
BATTERY CONNECTORS
REAR SHROUD
www.pridemobility.com
M A I N T E N A N C E
BATTERY WIRING DIAGRAM LABEL
REAR BATTERY
FRONT COVER
RELEASE HANDLES
FRONT BATTERY
Quantum 6000 Series