Power Elevating Seat Option
Your power chair may be equipped with a power elevating
seat option. While the seat itself may be any one of the
styles offered for this model, the way the seat base attaches
to the power base is different.
To install the power elevating seat:
l.
Place the seat plate interface bracket onto the actuator.
Seefigure 14.
2. Insert the supplied hardware into the actuator and tighten
the hardware.
3. Place the seating system onto the seat plate and secure.
Transit Securement System
If your power chair is equipped with a transit securement
system, it is equipped with manufacturer-installed front and
rear securement brackets and positioning belt anchoring
brackets. See figure 15. Refer to the supplement provided
with your power chair for information on how to use the
transit securement system.
NOTE: The transit securement system is an option
on Quantum 6000 models only.
SEAT PLATE
INTERFACE BRACKET
ACTUATOR
Figure 14. Power Elevating Seat Actuator
24
I V .
A S S E M B L Y
www.pridemobility.com
WIRE TIES
Figure 13. Controller Cable Routing on a Contour Seat
POSITIONING BELT
ANCHORING BRACKET
LOCATIONS
Figure 15. Transit System Securement Brackets
SECUREMENT
BRACKETS
(3 OF 4 SHOWN)
Quantum 6000 Series