Pride Mobility Quantum series Owner's Manual page 30

V . C O M F O R T
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat,
you can change the seat height either through the controller
or through a toggle switch mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat.
See figure 24.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run
more than a few seconds after the
mechanism reaches the top or bottom
limit.
NOTE: For more information on operating the power
elevating seat through the controller, contact your
Quantum Rehab Dealer.
WARNING! The power elevating seat
option is intended for use on a level
surface only. Never raise the seat from
its lowest position on an inclined
surface. Failure to heed this warning
can result in the power chair tipping
over.
WARNING! Never raise the seat from its
lowest position when operating your
power chair on bumpy or uneven
surfaces. Failure to heed this warning
can result in the power chair tipping
over.
WARNING! Never raise the power
elevating seat while your power chair
is in the freewheel mode.
W A R N I N G !
positioning belt before operating the
power elevating seat.
NOTE: The power elevating seat option is equipped
with a system that reduces the speed of the power
chair by one half when the seat is elevated more
than 2.5–5 cm (1–2 in.). Always check to be sure
this system is operating properly before using your
power chair.
30
A l w a y s f a s t e n t h e
www.pridemobility.com
A D J U S T M E N T S
Figure 24. Power Elevating Seat Toggle Switch
Quantum 6000 Series