Pride Mobility Quantum series Owner's Manual page 23

Seat Installation
It may be necessary to install the seat either prior to initial op-
eration or after transporting your power chair. Contour seats
are attached to the power base with the Universal Mounting
System (UMS). The UMS consists of universal parts that may
be attached to the seat, regardless of seat width or seat depth.
The two main components are aluminum extrusions mounted
to the seat base. These extrusions attach to a pair of trapeze
bars that are mounted to the power base. See figure 11.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat or a TRU-Balance 2 Power
Positioning System, refer to the information provided
in separate manuals.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 11.
2. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
3. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
4. Install the controller and route the cable to the back of
the power base. See figures 12 and 13.
5. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 6.
6. Plug the controller connector into the power base. See
figure 7.
7. Replace the rear shroud and tighten the rear shroud
fasteners. See figure 6.
8. Secure the controller cable to the armrest receiver with
wire ties (contour seats only). See figure 13.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest pad.
Route the harness under the armrest or
toward the inside of the armrest pad. Use
correct tie-down points for the controller
harness to prevent the harness from
getting caught in the drive tyres, pinched in
the seat frame or damaged when passing
through doorways.
Quantum 6000 Series
I V . A S S E M B L Y
www.pridemobility.com
SEAT LATCH SAFETY
REAR
EXTRUSION
Figure 11. Universal Mounting System and Contour Seat
Figure 12. Controller Cable Routing on a Synergy Seat
FRONT EXTRUSION
TRAPEZE BARS
23