Pride Mobility Quantum series Owner's Manual page 29

V . C O M F O R T
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several differ-
ent heights.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 21.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 21.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.
Quick Release Fasteners: The foot platform is attached
to the power base with two quick release fasteners. See
figure 21. Each quick release fastener consists of a bolt, a
lever and a nut. See figure 22. The lever has a cam on the
end that allows it to clamp into place. The quick release
fastener has two states: clamped and unclamped. When the
lever is open, the quick release fastener is unclamped. When
the lever is closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut anticlockwise one-quarter
or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the screw. See fig-
ure 23.
2. Turn the screw to raise or lower the front of the foot
platform.
Quantum 6000 Series
A D J U S T M E N T S
FOOT
PLATFORM
BRACKET
Figure 21. Foot Platform Adjustment
UNCLAMPED
Figure 22. Quick Release Fastener Operation
Figure 23. Underside of Foot Platform
www.pridemobility.com
QUICK RELEASE
FASTENERS
NUT
BOLT
LEVER (OPEN)
SCREW
LEVER (FULLY
CLOSED)
CAM
CLAMPED
29