ADJ Inno Pocket Wash User Instructions page 7

Inno Pocket Wash
SHND -
Show modes 0-4 (Factory programs). Show
mode can run with or without sound active mode active.
1. Press the MENU button until "SHND" is displayed, press
ENTER.
2. "Sh X" will now be displayed, "X" representing a number
between 0-4. Shows 1-4 are factory programs, while show "0" is
random mode. Use the UP or DOWN buttons to find your desired
show.
3. When you have found your desired show press ENTER, then
press and hold the MENU button for at least 3 seconds to acti-
vate. After you have set your desired show, it can be changed
at any time using the UP or DOWN buttons.
SOUN -
Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to activate sound active mode,
or "OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SENS -
In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until "SENS" is displayed, press
ENTER.
2. A number between 0-100 will be displayed. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least
sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to
confirm.
ADJ Products, LLC - www.adj.com - Inno Pocket Wash Instruction Manual Page 12
Inno Pocket Wash
System Menu
DNST
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until "DNST" is displayed, and either
"MASL", "BLND", or "LAST" will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
• LAST - If the DMX signal is lost the fixture will stay in the last
DMX setting. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
• MASL (Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode
and run a built-in show.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the
unit will automatically go into stand by mode.
3. Press ENTER to confirm your desired set up.
DIND -
1. Press the either the MENU button until "DIND" is displayed,
press ENTER. 1 of 5 dimmer curves will be displayed. "STDA"
(standard), "STGE" (stage), "TV" (TV), "ARAL" (Architectural),
or "THAL" (Theatre).
2. Press the UP or DOWN buttons to find your desired dimmer
curve and press ENTER to confim and exit
ADJ Products, LLC - www.adj.com - Inno Pocket Wash Instruction Manual Page 13
- This mode can be used as a precaution mode,
This will let select your desired dimmer curve.
System Menu
.