ADJ Inno Pocket Wash User Instructions page 4

Inno Pocket Wash
NOTICE: The suitable enviromental temperature for this light-
ing fixture is between -25˚ C to 45˚ C. Do not place this lighting
fixture in an enviroment where the temperatures are under or
above the temperatures stated above. This will allow the fixture
to run at its best and help prolong the fixture life.
Screw one clamp via a M12 screw and nut to the included
bracket. Attach the bracket using the included screws to the
bottom of the Inno Pocket Wash. Attach the eyehole screw to
the bottom of the base and pull the safety-cable through the
screw and over the trussing system or a safe fixation spot.
Insert the end in the carabine and tighten the safety screw.
ADJ Products, LLC - www.adj.com - Inno Pocket Wash Instruction Manual Page 6
Mounting
Inno Pocket Wash
Power Supply:
voltage switch, which will auto sense the voltage when it is plugged
into the power source. With this switch there is no need to worry about
the correct power voltage, this unit can be plugged in anywhere.
DMX-512:
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers. A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA "IN" and DATA "OUT" XLR terminals located on all DMX
fixtures (most controllers only have a DATA "OUT" terminal).
DMX Linking: DMX is a language allowing all makes and models
of different manufactures to be linked together and operate from a
single controller, as long as all fixtures and the controller are DMX
compliant. To ensure proper DMX data transmission, when using
several DMX fixtures try to use the shortest cable path possible. The
order in which fixtures are connected in a DMX line does not influence
the DMX addressing. For example; a fixture assigned a DMX address
of 1 may be placed anywhere in a DMX line, at the beginning, at the
end, or anywhere in the middle. Therefore, the first fixture controlled
by the controller could be the last fixture in the chain. When a fixture
is assigned a DMX address of 1, the DMX controller knows to send
DATA assigned to address 1 to that unit, no matter where it is located
in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX and Master/Slave
Operation): The Inno Pocket Wash can be controlled via DMX-512
protocol. The Inno Pocket Wash four DMX channel modes; 9 channel
mode, 11 channel mode, 19 channel mode, & 21
channel mode. The DMX address is set electroni-
cally using the controls on the front panel of the
unit. Your unit and your DMX controller require a
approved DMX-512 110 Ohm Data cable for data
input and data output (Figure 1). We recommend
Accu-Cable DMX cables. If you are making your
own cables, be sure to use standard 110-120 Ohm
shielded cable (This cable may be purchased at
ADJ Products, LLC - www.adj.com - Inno Pocket Wash Instruction Manual Page 7
The ADJ Inno Pocket Wash contains a automatic
DMX is short for Digital Multiplex. This is a universal pro-
DMX Set Up
Figure 1