Yada Backup Camera User Manual page 8

9. While sitting in the driver's seat of the car with the key in the accessory position. the monitor will
automatically start when connected to a power source. If when you place the vehicle in reverse there is
no image, go to the section "Pair and Connection" for more information.
10. Put the vehicle in reverse. If you have a clear picture, put the vehicle back in park and turn the key to the
off position. you are now ready for final steps.
11. take the Wireless transmitter and using the double sided Velcro attach the box to the inside of your car.
12. Use the provided Zip ties to secure wires neatly within your car.
13. replace the light socket back into the reverse light housing.
14. replace any interior panels that may have been removed to access the taillight and close your trunk or
rear hatch.
15. Standing with the license plate in one hand and the camera in the other hand, slide the Camera along
the top of the license plate in order to determine the placement. Best placement is in the center of the
license plate. If you have a rear hatch handle you may need to remove the camera bracket, turn the
bracket upside down and reattach to the camera. you would then mount the camera from the bottom
of the license plate.
16. Peel off the lining to the double-sided tape already attached to the Camera and press firmly to the
license plate to secure the Camera. make sure the back of the license plate is clean before attaching
double sided tape.
17. Press the license plate and the Camera mounting firmly to the car to secure and get full contact between
the license plate and the double-sided tape. Screw the license plate back onto the rear of your vehicle.
18. Once license plate and Camera are secure, you can adjust the vertical angle of the camera to your specific
need.
19. as a last check, note the position of the view from the camera when you place the vehicle in reverse.
adjust the angle of the camera as necessary to achieve the best rear view.
DIeSeL InStrUCtIOn:
temporarily connect the transmitter and camera following the wiring instructions above. then check the
camera image for rolling lines with vehicle running. If there are no rolling lines, permanently install the
components and wiring. If rolling lines occur you will need to run a power wire directly to the battery post
instead of using the reverse lights. then the power line will need to be cut and run to a switch near the driver
so the camera can be switched on/off. Without a switch the camera would drain the battery and possibly
burn out the camera. Be sure to use a fuse when connecting to the battery post.
6