Copying Tape (Tape Dubbing); Xd-Series (En - Kenwood XD-552 Instruction Manual

Copying tape
(Tape dubbing)
The contents of the tape in deck A can be copied onto the tape in deck B.
Load tapes in the decks.
A
Playing tape
1 Select the "TAPE" input.
2 Press the stop key.
#
¡
3 Select "
" (double-side recording) or " "
(one-side recording).
REV. MODE
4 Select "Tape Dubbing".
MENU
The following items can be selected by turning
the MULTI CONTROL jog dial.
"Recording Options"
"Tape Dubbing"
"Audio Options"
"Clock Options"
+Scrolled display
(Tape Dubbing)
T a p e D u b b
The DOLBY NR or TAPE EQ. key is ineffective
during dubbing.
The tape recorded on deck B assumes the same
Dolby NR condition as the tape played on deck A.
A
Recording tape
INPUT
& #
¡
SELECT
Lights
i
5 Use the same tape transport directions.
÷ When recording is started, the tape will be transported
in the direction selected in this step.
( > :side A, < : side B)
(1) Select the transport direction of deck A.
+Scrolled display
(Deck A Play Direction)
D
SELECT
A
(2) Select the transport direction of deck B.
+Scrolled display
(Deck B Record Direction)
D
SELECT
B
6
Start dubbing.
+Scrolled display (Press 'ENTER' to Start)
P r e s s ' E N
ENTER
÷ Dubbing ends automatically when the side(s) to be
dubbed has been completed.
To stop dubbing
REC/ARM
÷ The deck B will stop after creating a non-recorded
portion of about 4 sec, and then the deck A will stop.
÷ Dubbing can also be stopped by pressing the stop (&)
key of the cassette deck unit. Note that the non-
recorded space is not created in this case.
Let's record

XD-SERIES (En)

e c k A P l a
d e c k >
e c k B R e c
d e c k >
T
31