Kenwood VRS-6200 Instruction Manual page 19

Preparing for playback
7
Adjust the LFE LEVEL (Low Frequency Effects level)
Adjust the level of the low-frequency fields effect (LFE) signal, which is
the signal used exclusively for giving the field effect of bass tone, in the
Dolby Digital or DTS signal.
1 Use the MULTI CONTROL button (or the MULTI
CONTROL %/fi keys) to select "LFE LEVEL" on
setup displays, and press the SETUP key.
2 Use the MULTI CONTROL button (or the MULTI
CONTROL %/fi keys) to adjust the LFE LEVEL.
÷ The LFE LEVEL is adjusted from 0dB to -10dB in 1dB
step decrements.
3 Press the SETUP key to accept the setting.
4 Setup is complete when the EXIT indication appears.
5 Press the SETUP key to exit the SETUP mode.
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the "CLIP" indicator
will lights up. Adjust the input level.
1 Press the SOUND key repeatedly until the "INPUT"
indication appears.
2 Use the MULTI CONTROL button (or the MULTI
CONTROL %/fi keys) to adjust the input level.
÷ The adjustment mode is displayed for approximately 20
seconds.
÷ The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
÷ You can store a separate input level for each input selector.
3 Press the SOUND key again to return to the input
indication.
19 EN