Piper Dakota Maintenance Manual page 30

PERIODIC INSPECTIONS (cont)
Perform all inspections or operations at each inspection interval as
indicated by a circle (O).
D. FUSELAGE AND EMPENNAGE GROUP (cont)
31. Inspect security of Autopilot bridle cable clamps. (See Note 10.)..........................
32. Inspect all control cables, air ducts, electrical leads, lines, radio antenna
leads, and attaching parts for security, routing, chafing, deterioration,
wear, and correct installation...................................................................................
33. Inspect elt installation, condition of battery, and antenna. (See latest
revision of Piper Service Letter No. 820.)...............................................................
34. Reinstall inspection plates and panels .....................................................................
E. WING GROUP
l. Remove inspection plates and fairings....................................................................
2. Inspect surfaces and tips for damage, loose rivets, and condition of
walkway...................................................................................................................
3. Inspect aileron hinges and attachments ..................................................................
4. Inspect aileron control stops to insure stop has not loosened and locknut
is tight ......................................................................................................................
5. Inspect aileron cables, pulleys, and bellcranks for damage and operation..............
6. Inspect flaps and attachments for damage and operation .......................................
7. Inspect condition of bolts used with hinges. (Replace as required.) .......................
8. Lubricate per lubrication chart. (Refer to chapter l2.) ............................................
9. Inspect forward and aft wing attach fittings for corrosion, general condition and
security. (See latest revision of Piper Service Bulletin 977.)...................................
9a. Inspect wing attachment bolts and brackets ............................................................
10. Inspect fuel tanks and lines for leaks and water. (See Note l6.) .............................
11. Fuel tanks marked for capacity ...............................................................................
12. Fuel tanks marked for minimum octane rating........................................................
13. Inspect fuel cell vents. (See Note l5.) .....................................................................
14. Inspect all control cables, air ducts, electrical leads, lines, and attaching
parts for security, routing, chafing, deterioration, wear, and correct
installation ...............................................................................................................
15. Reinstall inspection plates and fairings ...................................................................
F. LANDING GEAR GROUP
1. Inspect oleo struts for proper extension. (Check fuid level as required.) ...............
2. Inspect nose gear steering control and travel...........................................................
3. Inspect wheels for alignment ..................................................................................
4. Put airplane on jacks ...............................................................................................
5. Inspect tires for cuts, uneven or excessive wear, and slippage ...............................
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL
—NOTE—
Nature of Inspection
1B6
Inspection Time (HRS)
50
100
O
O
O
O
O
O
O
O
O
O
O
O O
O
O
O
O
O
O
O
O
O O
O
O
O
O
Interim Revision: February 15, 1995
500 1000
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
O O
5 - 21 - 00
Page 5 - 07