Piper Dakota Maintenance Manual page 236

CHART 2701. TROUBLESHOOTING (SURFACE CONTROLS) (cont.)
Trouble
Excessive resistance to rudder
pedal movement. (cont)
Rudder pedals not neutral
when rudder is streamlined.
Incorrect rudder travel.
Trim control knob moves
with excessive resistance.
Lost motion between
control wheel and stabilator.
Resistance to Stabilator
control movement.
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL
Cause
RUDDER CONTROL SYSTEM (CONT.)
Cables not in place on
pulleys
Cables crossed or routed
incorrectly.
Rudder cables incorrectly
rigging.
Rudder bellcrank stop
incorrectly adjusted.
Nose wheel contacts stops
before rudder.
RUDDER TRIM CONTROL SYSTEM
System not lubricated
properly.
STABILATOR CONTROL SYSTEM
Cable tension too low,
Linkage loose or worn.
Broken pulley.
Cables not in place on
pulleys.
System not lubricated
properly.
Cable tension too high.
Binding control column.
1K3
Remedy
Install cables correctly. Check
cable guards.
Check routing of control
cables.
Rerig rudder cables.
Rerig bellcrank stops.
Rerig nose wheel stops.
Lubricate system.
Adjust cable tension.
Check linkage and tighten
or replace.
Replace pulley.
Install cables correctly.
Lubricate system.
Adjust cable tension.
Adjust and lubricate.
27 - 02 - 00
Page - 27 - 04
Reissued: August 1, 1986