Scope Of Delivery; Important Safety Instructions - Omnik Omnikhyd Inverter 3KW User Manual

1. Scope of delivery

The manual provides safety guidelines, detailed planning and setup information. It provides
procedures for installing the inverter and information about operation and troubleshooting of
the unit. This manual does not contain details about photovoltaic (PV) panels. Please consult
with system integrator for the information.

2. Important Safety Instructions

SAVE THESE INSTRUCTIONS — this user manual contains important instructions that shall be
followed during the installation and maintenance of the InfiniSolar Inverters. followed during the installation and maintenance of the Omnikhyd Inverters.
The following warnings identify conditions or practices that could result in personal injury or loss
of life.
1) Before installing and using the Solar Inverter, read all instructions and cautionary markings
on the inverter and all appropriate sections of this guide.
2) To reduce risk of fire hazard, do not cover or obstruct the inverter.
3) Under some conditions, the surface of Inverter case could be hot enough to cause skin
burns if accidentally touched. Ensure that the Inverter is located away from normal traffic
areas.
4) Use only accessories recommended or sold by the installer. Otherwise, not-qualified tool
may result in a risk of fire, electric shock, or injury to persons.
5) To avoid a risk of fire and electric shock, make sure that existing wiring is in good condition
and the wire is not undersized. Do not operate the Inverter with damaged or substandard
wiring.
6) Do not operate the Inverter if it has received a sharp blow, been dropped, or otherwise
damaged in any way. If the Inverter is damaged, call for an RMA (Return Material
Authorization)
7) Do not disassemble the Solar Inverter. It contains no user-serviceable parts. Attempting to
service the Solar Inverter yourself may result in a risk of electrical shock or fire and will void
warranty from manufacturer.
8) Authorized service personnel should reduce the risk of electrical shock by disconnecting
both the AC and DC power from the Inverter before attempting any maintenance or
cleaning or working on any circuits connected to the inverter. Turning off controls will not
reduce this risk. Internal capacitors can remain charged for 5 minutes after disconnecting
all sources of power.
9) Normally grounded conductors may be ungrounded and energized when a ground fault is
indicated.
Page 3 of 21 Rev. A