Listening To A Source Component; Adjusting The Sound - Kenwood KRF-V5050D Instruction Manual

Listening to a source component

INPUT SELECTOR
RC-R0511
1
Use the INPUT SELECTOR knob to select the source you
want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
VR-506/KRF-V6050D
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
if VIDEO2/MONITOR is VIDEO2
6 "VIDEO2"
7 "DVD/6ch"
8 "AV AUX"
else if VIDEO2/MONITOR is MONITOR
6 "DVD/6ch"
7 "AV AUX"
KRF-V5050D
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
if VIDEO2/MONITOR is VIDEO2
6 "VIDEO2"
7 "DVD/6ch"
else if VIDEO2/MONITOR is MONITOR
6 "DVD/6ch"
VR-505
1 "AUX"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
if VIDEO2/MONITOR is VIDEO2
6 "VIDEO2"
7 "DVD"
else if VIDEO2/MONITOR is MONITOR
6 "DVD"
VR-517/KRF-V5550D
1 "AUX"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
if VIDEO2/MONITOR is VIDEO2
6 "VIDEO2"
7 "DVD/6ch"
8 "AV AUX" (VR-517 only)
else if VIDEO2/MONITOR is MONITOR
6 "DVD/6ch"
7 "AV AUX" (VR-517 only)
VOLUME CONTROL
INPUT
SELECTOR
VOLUME
RC-R0615/R0617
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob (VOLUME keys) to adjust
the volume.
Selecting VIDEO 2/MONITOR
Depending on the component connected to the VIDEO 2/MONITOR
jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as
appropriate.

Adjusting the sound

MULTI CONTROL
SOUND
SPEAKERS A/B
(SPEAKER/MUTE)
PHONES
CONTROL
BASS BOOST/
RC-R0511
Adjusting the tone
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
2 Use the MULTI CONTROL keys to adjust the sound quality.
• The bass and treble levels are adjustable from -10dB to +10dB in 2
step increments.
• The adjustment item is displayed for approximately 8 seconds.
Once-touch low frequency emphasis (bass boost)
(remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo modes.
Press the B. BOOST (BASS BOOST) key.
• Press the key once to select the maximum (+10dB) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality or
ambience effects adjustment mode.
Switching back to the previous setting
Press the B. BOOST (BASS BOOST) key again.
Normal playback
SOURCE DIRECT
VOLUME CONTROL
SOUND
MULTI
B. BOOST
VOLUME
MUTE
RC-R0615/R0617
FM AUTO SOUND DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP
21
9
AUTO
MEMO
ST.
TUNED