Listening To A Source Component; Adjusting The Sound - Kenwood KRF-V7050D Instruction Manual

Listening to a source component

INPUT SELECTOR
INPUT
SELECTOR
1
Use the INPUT SELECTOR to select the source you want to
listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "VIDEO3"
8 "DVD/6ch"
9 "AV AUX"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or keys to adjust the
volume.
VOLUME CONTROL
VOLUME

Adjusting the sound

MULTI CONTROL
SOUND
SPEAKERS A/B
PHONES
SOUND
B. BOOST
MUTE
Adjusting the tone
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
2 Use the MULTI CONTROL knob or keys to adjust the sound
quality.
• The bass and treble levels are adjustable from -10dB to +10dB in 2
step increments.
• The adjustment item is displayed for approximately 8 seconds.
Once-touch low frequency emphasis (bass boost)
(remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
Press the B. BOOST key.
• Press the key once to select the maximum (+10dB) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality or
ambience effects adjustment mode.
Switching back to the previous setting
Press the B. BOOST key again.
Normal playback
SOURCE DIRECT
VOLUME CONTROL
MULTI
CONTROL
VOLUME
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR ST.
TUNED
kHz DOWN MIX DSP
19