Operation Of Your Opener; Care Of Your Opener; Maintenance Of Your Opener; Specification - Merlin RollerAce MR60 Installation And Operating Instructions Manual

OPERATION OF YOUR OPENER

Your opener can be activated by any of the following
devices:
• The green start button
Hold the button down until door starts to move.
• The wall control, outside keyswitch or keyless
entry system (if you have installed any of these
accessories).
• The transmitter or wireless wall control (84330AML)
Hold the push button down until the door starts to move.
When the opener is activated by transmitter, green start
button or wall control:
• If open, the door will close. If closed, the door will open.
• If closing, the door will stop.
• If opening, the door will stop (allowing space for entry and
exit of pets and for fresh air).
• If the door has been stopped in a partially open or closed
position, it will reverse direction.
• If an obstruction is encountered while closing, the door
will reverse.
• If an obstruction is encountered while opening, the door
will reverse and stop.
• The optional Protector System™ uses an invisible beam
which, when broken by an obstruction, causes a closing
door to open and prevents an open door from closing. It
is STRONGLY RECOMMENDED for homeowners with
young children.
Allow a 15 minute cooling period after 4 minutes of
continuous operation of the opener.
Opening the door manually:
Door should be fully closed if possible. Weak or
broken springs could allow an open door to fall
rapidly. Property damage or serious personal injury
could result.
The door can be opened manually by puling the release
cord down firmly.
To re-engage the door, pull the release cord down firmly
(refer section 11).
The opener light will turn on:
• when opener is initially plugged in;
• when the power is briefly interrupted;
• when the opener is activated.
(the light turns off automatically after 2-1/2 minutes).
SPECIAL NOTE: Merlin strongly recommends that the Protector System

CARE OF YOUR OPENER

When properly installed, your opener will operate with minimal
maintenance. The opener does not require additional
lubrication.
Limit and force settings: These settings must be checked and
properly set when the opener is installed. Weather conditions
may cause some minor changes in the door operation,
requiring some re-adjustments, particularly during the first
year of operation. Refer to limit and force setting in sections
12 & 13.
Follow the instructions carefully and repeat the safety
reverse test after any adjustment.
Transmitter: Additional transmitters can be purchased at any
time. Refer to accessories. Any new transmitters must be
programmed into the opener.
Transmitter battery: If transmission range decreases, replace
the battery.

MAINTENANCE OF YOUR OPENER

Once a month:
• Repeat safety reverse test.
Make any necessary adjustments (refer sections 12 & 13).
• Manually operate door. If it is unbalanced or binding, call
for professional garage door service.
• Check to be sure door opens and closes fully.
Set limits and/or force if necessary.
SPECIFICATIONS ROLLERACE - MR60
Input Voltage:
Rated Load:
Max.Pull Force:
Max. Door Mass
Idle Current:
Drive:
Max. Drum Rotations:
Memory Registers:
Operating Frequency:
TM be installed on all garage door openers.
14
230-240VAC, 50Hz, 85W
15Nm
450N @ O 300mm
60kg (spring balanced)
3 Watts nominal
DC gearmotor
permanent lubrication
4.5
64
433.92MHz