Patton OnSite 3300 Quick Start Manual page 6

PoE referenced in
Note
2.4 Connect the Power Source
The EFM Router does not have a power switch; it powers on once the device is plugged in.
The power connection is made via the barrel jack on the rear panel of the OS3300. No configuration is necessary
for the power supply.
2.5 Router/Bridge Status LEDs
The LEDs indicate the status of power, the WAN (OnSite) PoE, and Ethernet connections.
When powered down, the LED indicators are clear; when powered on, the LED indicators are yellow.
Note
LED Name
Power
R
OnSite Pair
(one LED for each port [1
on OS3301, 2 on
OS3302, 4 on OS3304])
PoE
Ethernet
(0/0 - 0/3)
6
Figure 6
applies to Ethernet 0/3 only.
OS3300 front panel LEDs
Table 1.
LED Function
ON
OFF
ON
OFF
ON
SLOW BLINK
FAST BLINK
OFF
ON
ON
OFF
Figure 7.
Description
Indicates power is applied.
WAN is configured as CO.
WAN is configured as CPE.
Port is configured as DOWN.
Port is in data mode.
Port is in handshake mode (looking for a CPE signal).
Port is in training mode (active communication with CPE).
PoE is turned off.
PoE is turned on.
Port is linked.
Data is passing over the port.
OS3300 front panel
OnSite 3300 Quick Start Guide