Listening To A Source Component; Adjusting The Sound - Kenwood KRF-V4550D Instruction Manual

Listening to a source component

18
INPUT
SELECTOR
VOLUME
1
Use the INPUT SELECTOR to select the source you want to
listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "DVD/6ch"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob (VOLUME keys) to adjust
the volume.
Selecting VIDEO 2/MONITOR
Depending on the component connected to the VIDEO 2/MONITOR
jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as
appropriate.
VOLUME CONTROL
INPUT SELECTOR

Adjusting the sound

MULTI CONTROL
PHONES
SPEAKER
BASS BOOST
Adjusting the tone
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
SP B TI.VOL
CLIP MUTE
RDS EON PTY
TP TA NEWS
2 Use the MULTI CONTROL to adjust the sound quality.
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 8 seconds.
Once-touch low frequency emphasis (bass boost)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
7
Press the BASS BOOST key.
• Press the key once to select the maximum (+10) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode.
Switching back to the previous setting
Press the BASS BOOST key again.
Normal playback
SOURCE DIRECT
SOUND
MUTE VOLUME CONTROL
SOUND
MULTI
CONTROL
MUTE
VOLUME
L C R
LFE SW
LS S RS
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR ST.
TUNED
kHz DOWN MIX DSP