Basic remote control operations for other components
DVD player operations
The remote control of this unit can control two groups of KENWOOD DVD players directly without using the
remote control supplied with the DVD player.
Group-1: DV-4900, DV-4070B, DV-2070, DV-203, DVF-9010, DVF-K7010, DVF-5010, DVF-R9030, DVF-
R7030, DVF-3530 and DV-402
Group-2: DV-4050, DV-303, DVF-R6030, DVF-K5020, DVF-5020, DVF-3020 and DVF-3030
Depending on your KENWOOD DVD model, you need to set up your receiver remote control as follows:
To set for Group-1 DVD players:
Press the numeric "1" key while pressing the "POWER" key (not the DVD Power key) on your remote
To set for Group-2 DVD players:
Press the numeric "2" key while pressing the "POWER" key (not the DVD Power key) on your remote
• If your DVD player is not listed in the list above, perform the set up for either Group-1 or Group-2.
When the set up is successful, then your DVD player falls into that particular group.
How to operate the DVD player with the remote control
1. Pressing the DVD Power key for more than 2 seconds turns the DVD player on or off.
2. To carry out the functions of the DVD player, first press the DVD Power key, then press each key
for each operation as explained in the DVD operation pages in the operating instructions. In this case,
the DVD operation mode is retained for 15 seconds after pressing any of those DVD operation
(To turn the receiver operation mode within 15 seconds, press the RECEIVER key.)
DVD player operation keys
You can perform these basic operations using the keys described below when connected to KENWOOD DVD
OSD (OSD Menu)
PHONO CD/DVD TUNER
6 (3 Play)