Recording; Recording Audio (Analog Sources) - Kenwood KRF-V4550D Instruction Manual

Muting the sound
The MUTE key lets you mute the sound of the speakers.
Press the MUTE key.
SP B TI.VOL
L
CLIP MUTE
LFE
RDS EON PTY
LS
TP TA NEWS
Blinks
To cancel
Press the MUTE key again so that the "MUTE" indicator goes off.
• Muting can also be canceled by adjusting the volume.
SOURCE DIRECT playback (analog sources only)
Use this function to pass the source material direct to the amplifier,
bypassing any audio processing.
Press the SOURCE DIRECT key.
FM AUTO SOUND DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP TUNED
• When you press the LISTEN MODE, SOUND, or SET UP keys, or
switch to another input source, SOURCE DIRECT playback will be
canceled.
To cancel
Press the SOURCE DIRECT key again.
• If SOURCE DIRECT playback was activated when using a surround
mode, cancelling it reactivates the previous surround mode.
Listening with headphones
1 Press the SPEAKER key so that the speaker indicator goes off.
Make sure the SP indicators
are turned off.
SP A B TI.VOL
CLIP MUTE
RDS EON PTY
TP TA NEWS
• If you turn off all of the speakers when in the surround mode, the
mode is canceled as well, resulting in stereo playback.
• The speakers do not switch off during the 6ch INPUT mode.
Select the other input mode.
2 Connect headphones to the PHONES jack.
3 Use the VOLUME CONTROL (VOLUME) to adjust the volume.
Normal playback
C R
SW
S RS
AUTO
MEMO
ST.
L C R
LFE SW
LS S RS

Recording

Recording audio (analog sources)

Recording a music source
When recording a music source, switch the VIDEO2/MONITOR
setting to "MONITOR" .
1 Use the INPUT SELECTOR knob to select the source (other than
"MD/TAPE") you want to record.
2 Set the cassette deck to record.
3 Start playback, then start recording.
Recording tapes or MD (with MONITOR function)
When recording a music source, switch the VIDEO2/MONITOR
setting to "MONITOR".
MONITOR = MD/TAPE recording
1 Press the MONITOR key.
2 Use the INPUT SELECTOR knob to select a source other than
"MD/TAPE."
3 Start playback on the cassette deck connected to the MONITOR
jacks and start recording on the cassette deck connected to the
MD/TAPE jacks.
MD/TAPE = MONITOR recording
1 Use the INPUT SELECTOR knob to select "MD/TAPE."
2 Start playback on the cassette deck connected to the MD/TAPE
7
jacks and start recording on the cassette deck connected to the
VIDEO2/MONITOR jacks.
• To copy tapes using a double cassette deck, refer to the instruction
manual of the double cassette deck.
MONITOR function (analog sources only)
You can connect a cassette deck or graphic equalizer to the VIDEO2/
MONITOR jacks of the receiver. If a graphic equalizer is connected,
the MONITOR key should be left in the on position. Alternately, if a
cassette deck equipped with a 3-head system is connected to the
VIDEO2/MONITOR jacks, you will be able to monitor the just-
recorded signal while making recordings on the cassette deck. By
switching the MONITOR key on and off, you can compare the sound
of the source signal and the just-recorded signal. For more informa-
tion, refer to the instruction manual of the connected component.
MONITOR
INPUT SELECTOR
FM AUTO SOUND DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP TUNED
19
7
7
AUTO
MEMO
ST.