JVC KS-LX200R Service Manual page 7

Removing the operation assembly
Prior to performing the following procedure, remove
the top chassis assembly, the front panel assembly
and the lifer unit.
1. Remove the three screws S attaching the right and
left brackets which fix gears on both sides of the
operation assembly.
2. Remove the springs 5 and 6 from the operation
assembly.
3. Disconnect the card wire from connector CN702 on
the main board and remove the operation assembly.
ATTENTION: When reassembling, correctly engage the
switch S561 and S562 on the main board
and the right gear with the part c of the
operation assembly.
Bracket (R)
S652
(See Fig.16 to 19)
Operation assembly
S651
Fig.19
Bracket (R)
S
Spring 5
Operation assembly
c
c
KS-LX200R
Bracket (L)
S
CN702
Spring 6
Fig.16
S652
S651
Operation assembly
Fig.17
Operation assembly
Fig.18
c
1-7