Automatic Clock Adjustment - JVC KS-LX200R Service Manual

Changing the display mode while
listening to an FM station
You can change the initial indication on the display
to either station name (PS NAME) or to station
frequency (FREQ), while listening to an FM RDS
station.
• See also "Changing the general settings (PSM)"
on page 21.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2
Press
(tuner display).
3
Press + or – to set to the desired indication ("PS
NAME" or "FREQ").
Note:
By pressing DISP, you can also change the display while
listening to an FM RDS station.
Each time you press the button, the following information
appears on the display:
Station Frequency
Programme type
• Then, the display goes back to the original indication
in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
• See also "Changing the general settings (PSM)"
on page 21.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2
Press
3
Press + or – to set to the desired volume.
You can set it from "VOL 00" to "VOL 50."
14
to select "TU DISP"
Station name
(PS NAME)
(FREQ)
(PTY)
to select "TA VOL."

Automatic clock adjustment

When shipped from the factory, the clock built in
this unit is set to be readjusted automatically using
the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also "Changing the general settings (PSM)"
on page 21.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2
Press
3
Press – to select "ADJ OFF."
Now automatic clock adjustment is canceled.
To reactivate clock adjustment, repeat the same
procedure and select "ADJ ON" in step 3 by
pressing +.
Note:
It takes about 2 minutes to adjust the time using the CT
data. So, you should not change the station for more
than 2 minutes continuously; otherwise, the clock time
will not be adjusted.
to select "AUTO ADJ."