JVC KS-LX200R Service Manual page 10

KS-LX200R
Removing the load arm assembly
Prior to performing the following procedure, remove
the connector board.
1. Remove the slit washer e retaining the load arm
assembly.
2. Remove the spring g in the load arm assembly
marked joint f.
3. Draw out the load arm assembly from the shaft and
rotate in the direction of the arrow to remove it from
the cach.
ATTENTION: The spring g comes off as the load
arm assembly is drawn out from the
shaft.
Removing the sub chassis (See Fig.4)
Prior to performing the following procedure, remove
the connector board and the load arm assembly.
1. Remove the two screws D
chassis.
2. Draw out the sub chassis from the holder arm shaft
in the direction of the arrow (marked joint h).
Remove the sub chassis from the main chassis
upwards.
Removing the cassette holder / holder
arm (See Fig.5)
Prior to performing the following procedure, remove
the connector board and the load arm assembly.
1. Remove the screw E attaching the cassette holder /
holder arm.
2. Draw out the holder arm shaft from the sub chassis
in the direction of the arrow (marked joint h).
3. Disengage two joints i and remove the cassette
holder / holder arm.
1-10
(See Fig.4)
Holder arm
Cach
Main chassis
attaching the sub
Joints
Load arm assembly
h
Joint
Cassette holder
Fig.4
E
Holder arm
i
Cassette holder
Main chassis
Fig.5
D
Load arm assembly
e
Slit washer
f
Joint
Load arm
assembly
g
Spring
Worm gear
D
Sub chassis
h
Joint
Sub chassis