Panel Wall Construction Type - McQuay PDAA Installation & Maintenance Data

Installation of Basic Wall Sleeve
Figure 16. Frame and brick with electrical subbase
Outside
Louver
Mounting
Holes
(by installer)
Wall Sleeve
Caulk Perimeter
both Indoor and
Outdoor Before
Installing Louver
Note: Standard subbase is available in 3" or 4"
(76 mm or 102 mm) height. Leveling legs
provide adjustment of 1" (25 mm)
Figure 17. Frame and brick with cord connection
Mounting
Screws
by Installer
(349mm)
Outdoor
Louver
Wall Sleeve
Caulk Perimeter
IM 934-2 Applied PDAA/PDHA / Page 14 of 44
Steel Lintel
(by others)
"
4 3 /
8
(111mm)
13 "
3 /
4
(349mm)
8 "
1
/
4
(209mm)
16"
(432mm)
(406mm)
Room
Cabinet
Subbase
See Note
Leveling
Finished Floor
Leg
Power Supply Connect
(Alternate Entry)
.
Steel Lintel
(by others)
13 "
3
/
8 "
1
4
/
4
(209mm)
16"
(432mm)
(406mm)
Room
Cabinet
3" Min. (76mm)
Wall
Finished Floor
Receptacle
or Carpet
(by others)
Figure 18. Frame and brick with hydronic subbase
Outdoor Louver
Mounting
17"
Screws
by Installer
Caulk Perimeter
both Indoors
and
Outdoors
Before Installing
Louver
or Top
Subbase Side
of Carpet
Channel

Panel Wall Construction Type

For panel wall and thin wall construction, it is
recommended that a louver frame be used (See Louver
Frame Installation For Thin Wall Types on page 11,
and figures 19, 20 & 21).
Panel wall and thin wall construction varies only
slightly from frame and brick construction. Note: The
center of gravity is 10" (260mm) from the rear face of
the wall sleeve. The wall sleeve must be inserted into
the wall at least 10" (260mm) or other support must
be employed. Support can be from a factory supplied
subbase or from other field supplied materials.
Installation for this application is as follows (Figures
17"
19, 20, & 21).
1. Clean the opening of all debris that may interfere
with installation.
2. If the unit is to be supplied with a subbase, install
subbase before installing wall sleeve (see IM 936).
3. If the optional drain kit is to be employed, see IM
942.
4. Be sure the wall sleeve is mechanically attached
to the wall and caulked to assure a proper seat. It
is recommended that the louver frame be used for
this purpose.
Steel Lintel
(by others)
13 "
3
/
8 "
1
4 /
(349mm)
4
(209mm)
16"
(406mm)
Room
Wall Sleeve
Cabinet
Alternate
Electrical
Hydronic Subbase
Connections
17"
(432mm)
Hydronic
Heating
Coil
8 "
1
/
4
(209mm)
Finished Floor
or Carpet
Leveling Leg