McQuay PDAA Installation & Maintenance Data page 30

Controls
Premium Digital Touchpad Control
Clock Set Menu
To set the time and day of the week, press
1.1
FAN MODE and FAN SPEED buttons
simultaneously for 5 seconds. Time will be
displayed first:
AM
9:45
Adjust the time by pressing
1.2
By holding pressed
change in 15 minutes increments or decrements,
respectively. AM and PM will show in rotation.
1.3 By pressing FAN MODE button, move to
the confirmation day of the week. Numbers
represent days of the week, Monday being 1 and
so forth. TODAY will flash on display. Adjust
the number that represents the day of the week
by pressing and
TODAY
AM
9:45
Exit the clock set menu by pressing FAN
1.4
MODE (TIME) and FAN SPEED (DAY)
simultaneously for 5 seconds
Configuration
The configuration mode is meant for temperature scale
setting, limits for minimum and maximum operating
temperatures and displaying sensor readings. To
enter the configuration mode hold pressed
buttons for 5 seconds. Moving from one screen
to another and rolling over is done by pressing Mode
button.
Once in the configuration mode, the default
2.1
temperature scale will be displayed as shown
below. Toggle the temperature scale to degree
Celsius by pressing either
IM 934-2 Applied PDAA/PDHA / Page 30 of 44
and buttons.
buttons, time will
or
buttons:
and
button:
or
To adjust the lower operating temperature limit
2.2
(cool minimum set point) press
buttons. COOL and the setting will be displayed
as shown below. The minimum and factory
default setting is 60°F (15°C). An example of
what can be displayed:
To view the upper operating temperature limit
2.3
(heat maximum set point) press MODE button.
HEAT will be displayed. An example of what
can be displayed:
To adjust the upper operating temperature limit
2.4
(heat maximum set point) press
buttons. The max and factory default setting is
85°F (30°C). When Control selection jumper
on control board is set for "T'STAT," the max
setting can go up to 90°F (32°C).
By pressing MODE button repeatedly from the
2.5
previous screen, the following will be displayed
in sequence:
• Indoor air sensor reading
• Indoor coil sensor reading
• Outdoor air sensor reading
• Outdoor coil sensor reading
Exit the configuration mode by pressing
2.6
buttons for 5 seconds
and
and
and