Installation Of Condensate Drain Kit - McQuay PDAA Installation & Maintenance Data

Installation of Optional
Condensate Drain Kit
Figure 10 illustrates the installation of the indoor
drain kit. The indoor drain kit must be installed before
placing the wall sleeve into the opening. Install as
follows:
1. Locate the drain so that it will be on the room side
of the wall when the wall sleeve is installed.
2. Drill a 1/2" diameter hole in the base of the wall
sleeve for the drain.
3. Drill two (2) 5/32" pilot holes for the mounting
screws. These holes can be located using the drain
kit as a pattern.
4. Assemble the drain kit as shown in Figure 10 and
securely fasten it to the wall sleeve with the
screws provided. Use either the 90
straight fitting as required.
5. Install the wall sleeve as described on pages
11-16.
Figure 10. Indoor Drain Kit
Contractor To Drill
Three (3) Holes
To Accept Drain Kit
Figure 11. External Drain Kit
Note: Use of 6" straight drain tube will require modification of architectural louver.
IM 934-2 Applied PDAA/PDHA / Page 10 of 44
elbow or 6"
o
Square Drain Holes
Neoprene Sponge Gasket
Steel Mounting Plate
Square Drain Holes
Neoprene Sponge Gasket
Steel Mounting Plate
Assembly of the outdoor drain kit should be
completed after the wall sleeve has been installed.
Note: When using the outdoor drain kit, the sleeve
must be flush or beyond the outside finished
wall (do not recess).
Install the external drain kit as follows:
1. Assemble the drain kit as shown in Figure 11.
2. Choose the side of the wall sleeve to which the
drain kit is to be installed.
3. There are drain holes and pilot holes provided in
the wall sleeve from factory. Place the drain kit
against the chosen drain hole and fasten securely
with screws provided. Use either the 90
6" straight fitting as required.
4. Cover the unused drain hole with the block off
plate and gasket supplied with the drain kit.
See Detail
Cover
Plate
Screws
" (13mm) O.D. Drain Tube
1
/
2
Alternate 6" Long, 1/2" O.D.
Straight Copper Tube
elbow or
o
Detail
Gasket
Cabinet
Bottom
1/2"
(13mm)
O.D.
Cover
Tube
Plate