Table of Contents
Advertisement
Note: Heat pump models will generate condensate during
the heating season. To insure that no condensate will run
down the building, always use a drain kit with the heat pump.
Condensate drain kits can be supplied for internal or external
applications. Figure 14 illustrates the installation of the indoor
drain kit. The indoor drain kit should be installed before placing
the cabinet/wall sleeve into the opening. Install as follows:
1. Locate the drain so that it will be on the room side of the wall
when the cabinet/wall sleeve is installed.
Figure 14. Internal Drain Kit
Contractor To Drill Three (3) Holes
To Accept Drain Kit
Assembly of the external drain kit should be completed after the
cabinet/wall sleeve has been installed. Install the external drain
kit as follows:
1. Assemble the drain kit as shown in Figure 15.
2. Choose which side of the cabinet/wall sleeve the drain kit is
to be installed.
Figure 15. External Drain Kit
Note: Use of 6" straight drain tube will require modification of
architectural louver.
Installation of Optional Condensate Drain Kit
Square Drain Holes
Neoprene Sponge Gasket
Steel Mounting Plate
Square Drain Holes
Neoprene Sponge Gasket
Steel Mounting Plate
1
2. Drill a
/
" (13mm) diameter hole in the base of the cabinet/
2
wall sleeve for the drain line.
5
3. Drill two (2)
/
" (4mm) pilot holes for the mounting screws.
32
These holes can be located using the drain kit as a pattern.
4. Assemble the drain kit as shown in Figure 14 and securely
fasten it to the cabinet/wall sleeve with screws provided.
5. Slide the cabinet/wall sleeve into the opening and anchor it
into place.
See Detail
Cover Plate
Screws
3. There are weep holes and pilot holes provided in the cabinet/
wall sleeve from the factory. Place the drain kit against the
chosen weep hole and fasten securely with screws provided.
4. Cover the unused weep holes with the block off plate
supplied with the drain kit.
1
/
" (13mm) O.D. Drain Tube
2
Alternate 6" Long, 1/2" O.D. Straight
Copper Tube
Gasket
Cabinet Bottom
1/2" (13mm) O.D.
Cover Plate
Tube
IM 368 / Page 9 of 20 (Rev. 11/03)
Advertisement
Table of Contents
