Controls And Indicators - Kenwood C-V351 Instruction Manual

Controls and indicators

RDS indicators
(RDS, TP, TA, EON, PTY, NEWS, INFO.)
MEMORY indicator
RDS INFO.
MEMO
FM
EON NEWS
PTY TP TA
MW
TIMER 1 2
LW
TIMER
Broadcast band
indicators indicators
1 2
ON/STANDBY
PHONES
INPUT TAPE 2
(MONITOR)
!@
The keys which have the same names as the controls on the
remote control unit provide the same functions as them.
1
(ON/STANDBY) key
Press to switch between ON and STANDBY.
2 Remote sensor
3 TIMER SET key
Press to set the timer function.
4 CLOCK key
Press to set the clock.
5 STEREO key
6 DSP key
7 DOLBY key
8 MODE key
Press to switch various setting modes.
9 MULTI.CONTROL key
Press to select various setting modes.
0 GRC transmitter
Outputs the signals transmitted to the
Graphical Remote Control.
! PHONES jack
For use in headphones listening.
@ INPUT SELECTOR key
Press to select the input.
# TAPE 2 (MONITOR) key
For use in monitoring of recording, etc.
Standby mode
While the standby indicator of the unit is lit, a small amount of current is flowing into the unit's internal circuitry to back up the memory. This condition
is referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit.
With this unit, standby mode is indicated by means of the display panel. The system is in standby mode while the clock display is shown.
Frequency display, input
selector display, preset
channel display, surround
mode display
3 4
TIMER
SET CLOCK
TIMER RDS
MODE S.DIRECT DISPLAY PTY TA/NEWS/INFO.
AV CONTROL CERTER KC-2
#$ % ^ & *
$ TIMER MODE key
Press to switch the timer modes.
% S.DIRECT key
Press to switch the Source Direct function
which allows to reproduce the source with
a better quality.
^ RDS DISPLAY key
Press to switch the RDS display.
& RDS PTY key
For use during reception of RDS broadcast-
ing.
* RDS TA/NEWS/INFO. key
For use during reception of RDS broadcasting.
( A.MEMO key
Press when using the auto memory func-
tion.
) AUTO key
Press to select the tuning mode.
The auto tuning or manual tuning mode can
be selected.
The input selection display of a source can
be switched to another by pressing and
holding the AUTO key for more than 2
seconds.
Decibel indicator
Delay time indicator
dB
ms
kHz
MHz
DSP indicator
Receiving frequency
unit indicators
Display
5 6 7 8 9
MULTI.CONTROL
MODE
STEREO DSP
LEVEL
PTY SELECT
A.MEMO AUTO BAND
TUNING
( ) ¡ ™
0
AUTO tuning mode/AUTO stereo
PRO LOGIC
reception indicator
indicator
TAPE 2
indicator
STEREO indicator
PRO LOGIC PRO LOGIC TAPE 2 AUTO
3 STEREO SOURCE STEREO
DIRECT
DSP DSP TUNED
SLEEP MUTE
SLEEP
TUNED indicator
TIMER
indicator
MUTE indicator
3 STEREO
SOURCE DIRECT indicator
indicator
0
VOLUME CONTROL
OPEN/CLOSE
DOWN UP
£ ¢
¡ BAND key
Press to switch the broadcasting band.
™ TUNING key (
, )
Press to select the radio station to be re-
ceived.
These keys are also used in the clock adjust-
ment and timer operations.
£ OPEN/CLOSE key
¢ VOLUME CONTROL knob
C-V351/C-V301 (EN)
9