Setting Up The Grc According To Your Av Control Center (Model Type Setup) - Kenwood C-V351 Instruction Manual

Setting up the GRC according to your AV CONTROL CENTER
12
Perform the following procedure after inserting batteries for
the first time and every time after changing them.
Preparation
Model Type Setup (GRC setup procedure)
1
Loading batteries
1 Remove the cover.
2
3
2
Check the display.
The "Model Type Setup" screen ap-
pears.
3
Select "Model 2."
Move the cursor.
The icon on which the cursor is moved blinks in reverse
video.
4
Enter the selection.
Press the ENTER key.
÷ Press the
(ON/STANDBY) key
of the main unit to the ON mode.
2 Insert batteries.
It can be moved in 8 directions depend-
ing on how you press the joystick key.
ENTER
ENTER
Setup of the Graphical Remote Control (GRC) unit
3 Close the cover.
Model Type Setup
Model 1 Model 4
Model 2 Model 5
Model 3 Model 6
AV CONTROL CENTER
Model
C-V301 ............................................... Model 2
C-V351 ............................................... Model 2
To reset GRC setting
1 Select Set Up.
2 Press the ENTER key.
3 Select Reset.
4 Press the ENTER key.
5 Perform the setup procedure from step "2 Check the display".
÷ The above operation clears all of the previously made settings and
resets the unit to the initial condition.
C-V351/C-V301 (EN)
(Model Type Setup)
Model Type Setup
Model 1 Model 4
Model 2 Model 5
Model 3 Model 6
Main operation menu
Caution in battery replacement
÷ Insert four AA-size (R6/AA) batteries
as indicated by the polarity marking.
÷ To maintain the memory of the settings you
made before, complete the battery replace-
ment operation within 30 seconds.
÷ The procedure on the left should also be per-
formed when resetting the GRC (as a measure
against its malfunction). However, in this case,
wait for about five minutes after removing the
batteries and before re-inserting them.
GRC
"Model Type Setup" icon
Set Up
ENTER
Reset
ENTER
For C-V351
ENTER
VOLUME
MUTE
ON/STANDBY