About The System Control Connections; Connection Of Flat-Cable Connector - Kenwood C-V351 Instruction Manual

About the system control connections

When this unit is connected to KENWOOD audio component system "SERIES 21", also connect them through the system control cords
to allow system-control operations between components.
Connection example
AV
CONTROL
CENTER
POWER
AMPLIFIER
GRAPHIC
EQUALIZER
CASSETTE
DECK
CD
PLAYER
About the system control operations
(Available operations when SERIES 21 components are connected through system control cords)
Remote Control
Lets you operate source components with the system remote supplied with this unit.
Automatic Operation
When you start playback from a source component, the input selector on this unit switches to that component automatically. (Except TAPE 2)
Synchronized Recording
Lets you synchronize recording with the start of playback when recording from CD or LD.

Connection of flat-cable connector

Inserting the connector
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging / unplugging
Notes Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
4. If the system control cords or audio cords are not connected properly, the remote control or automatic operation between system
components will not work properly.
SYSTEM
CONTROL
System
control cord
SYSTEM
CONTROL
SYSTEM
CONTROL
System
control cord
System
SYSTEM
control cord
CONTROL
Push in the
connector straight
into the socket until it
clicks to indicate the
locking.
Removing the connector
System connection
C-V351/C-V301 (EN)
The SERIES 21 components which can be
system-connected with this unit include
the LD player, MD recorder, and DVD player.
Notes Notes Notes
1. Do not connect the SERIES 21 components
to other system components using system
control cords.
2. Do not connect system control cords to any
components other than those specified by
KENWOOD. It may cause a malfunction and
damage your equipment.
3. Be sure the system control plugs are in-
serted all the way in to the system control
terminals.
Push and hold the two ends of the
connector, and pull it straight
outward.
7