Adjustment; Creating Reference Data; Checking Reference Data; Reference Data - Hitachi DZ-GX5020A K Service Manual

6

Adjustment

6-1 Creating Reference Data

The reference data is necessary for adjustment: The adjustment software will not operate normally
without it. Before adjustment, be sure to create the reference data, using the same model (with
normal camera block) as the one to be adjusted.
The reference data is used to reduce the difference between environments of servicing site and
factory (color temperature of light box, etc.). Using the reference data will increase adjustment
accuracy.

6-1-1 Checking Reference Data

Before starting adjustment, check whether it will be necessary to create the reference data or not,
referring to the fl owchart below:
Creation of reference
data needed or not
Have you ever created
reference data for
this model?
Yes Will you use
the same PC as when
you created the

reference data?

Will you use the same
light box as when you
created the reference

data?

Did you perform
maintenance on the light
box after creating
the reference data?
Will you use the same
C12 light balancing
filter as when you
created the reference
data?
Use the reference data
created in the past to
perform adjustment.
No
Yes
Does the "map07w"
No
folder exist on HDD
of PC used to create
the reference data?
Yes
Copy the "map07w" folder
from the PC on which you
created the reference
data.
No
Yes
Yes
No
No
Create the reference data.
Yes
Fig. 6-1-1 Reference Data Check Flowchart
6 - 1
No
Create the reference data.
Yes