Hitachi DZ-GX5020A K Service Manual page 36

Troubleshooting > Messages and Troubleshooting
Message
Disc is not formatted.
Format the disc now?
YES NO
[Displayed only when DVD-
RW is used]
All data will be deleted.
Select record format.
VR mode VF mode
Drive overheat.
Please retry later.
DVD-R Disc, 16:9 mode
cannot be changed, when
Video mode is STD
DVD-RW (VF) Disc, 16:9
mode cannot be changed,
when Video mode is STD
DVD+RW Disc, 16:9 mode
cannot be changed, when
Video mode is STD
DVD-R Disc, Input Source
cannot be changed.
DVD-RW (VF) Disc, Input
source cannot be changed.
DVD-R Disc , Video mode
and 16:9 mode cannot be
changed.
DVD-RW (VF) Disc, Video
mode and 16:9 mode cannot
be changed.
Cause/condition for
message to appear
Appears when a brand-new DVD-RW/
+RW was loaded.
Appears when reading or writing from/to
recorded fi le cannot be performed
because the disc is dirty.
May appear when a disc formatted and
recorded on a device other than DVD
video camera/recorders is loaded.
Appears when an unformatted
DVDRAM/DVD-RW/+RW or one
initialized (other UDF2.0) on PC is
loaded.
Also appears if user rejects partial repair
or total repair of video fi le.
Appears when the temperature inside
the DVD video camera/recorder, or the
temperature of disc, is too high, and
normal operation cannot be executed.
Appears when the wide-screen mode was
chosen with the video quality set to STD
using a DVD-RW (VF mode)/DVD-R/+RW:
The combination of STD (352 × 480
pixels) and wide-mode is prohibited by
the DVD video format.
Appears when an attempt was made to
switch the input with a DVD-RW (VF
mode)/DVD-R recorded in wide mode:
Only the 4:3 aspect screen is possible for
external input.
This is because the DVD video format
prohibits the mixing of 16:9 and 4:3
aspect screens.
Appears when an attempt was made to
change the video quality or wide mode
of recorded DVD-RW (VF mode)/DVD-R.
This is because, if even one scene is
recorded after a disc is formatted, the
specifi cations state that the video quality
or wide mode used for the fi rst recording
will be held on the DVD-RW (VF mode)/
DVD-R.
4 - 8
Troubleshooting
When recording on the DVD video
camera/recorder, choose "YES/
VR Mode/VF Mode" and designate it.
Refer to "4-3-5 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Use a PC, etc. to check the contents
on disc.
When initializing it (deleting all
recorded data), choose "YES" and
designate it.
Choose "NO" and designate partial
repair or total repair. When
initializing it (deleting all recorded
data), choose "YES" and designate it.
Set the power switch to "OFF" with
the disc loaded, and then leave the
DVD video camera/recorder in a
well-ventilated place until the inside
temperature decreases.
Change the video quality to XTRA or
FINE when using a brand-new DVD-
RW/DVD-R/+RW. If the DVD-RW/
DVD-R/+RW has already been
recorded in STD mode, replace it.
Stop trying to switch the input, or
replace the disc.
Stop trying to change the video
quality or wide mode, or replace the
disc.