Hitachi DZ-GX5020A K Service Manual page 33

Troubleshooting > Messages and Troubleshooting
Message
Data error in all image fi le.
Repair all data now?
YES NO
DISC ACCESS
*3: Take care with the following when repairing video fi le:
a) If any message appears when the power switch was moved from "OFF" to "Movie" or "Disc Still" with
the disc left loaded after camera recording, choose repair.
b) If recording and playback are possible with another disc, which is free from condensation or dirt, choose
repair.
c) Be sure to connect the AC adapter/charger: The specifi cations state that repair is possible only when the
AC adapter/charger is connected.
d) Although repair is normally fi nished in several minutes, it could take approx. one hour.
e) If the disc is removed while it is being recognized, the repair function of movie fi le will be invalid.
f) If the timing when power is turned off is inappropriate, normal repair may be impossible.
g) If the disc contains data recorded on a device other than DZ-GX5080A/GX5020A/GX5000A, normal
repair may not be possible.
h) The repaired data may be different from the original recorded content because of partial deletion of a
defective portion.
i) The repaired data (only corrected portion in case of partial repair) will lose the original date/time
information because the information for date/time when repair was executed will be added.
j) If "all repair" is executed, repair will be made in the order of all videos and all photos, and the time-
sequential relationship of recorded contents may be lost.
Cause/condition for
message to appear
Appears when reading/writing of
recorded fi les cannot be performed
because the disc is dirty. If the message
appears immediately after recognition of
a loaded, recorded disc was fi nished, fi rst
check for dirt on disc
Appears if writing to fi le cannot be
completed normally because power
was turned off by mistake during movie
recording or editing, and it is recognized
that the movie fi le must be totally
repaired.
This message appears during normal
operation process, when the DVD video
camera/recorder checks whether a
proper disc has been loaded or not. It is
displayed for a longer time period when
the date has changed.
This message appears during normal
operation process, when the recorded
images are being stored on disc.
4 - 5
Troubleshooting
Refer to "4-3-5 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Choose "YES" and designate total
repair (automatic repair) of movie
fi le. Choosing "NO" will display a
message for verifying initialization.
[Refer to *3]
Operate the DVD video camera/
recorder after the message disap-
pears.
Operate the DVD video camera/
recorder after the message disap-
pears.