Hitachi DZ-GX5020A K Service Manual page 39

Troubleshooting > Messages and Troubleshooting
Message
There was no scene which
can be deleted.
This disc cannot be used.
Please replace disc.
This disc is fi nalized.
Finalize is not required.
This disc is recorded by the
PAL system.
Please replace disc.
UNFORMAT DISC
Use AC adapter/charger.
Use AC adapter/charger.
Turn off power.
Write protected.
Check card.
Write protected.
Check disc.
Note:
The listed messages are subject to change without notice for improvement of performance.
Cause/condition for
message to appear
Appears when only multiple locked
scenes were selected using the Disc
Navigation function, and deleting them
was attempted.
Appears when a type of disc that cannot
be used on the DVD video camera/
recorder was loaded.
Appears when the FINALIZE button
was pressed with a fi nalized DVD-RW
(VF-mode)/DVD-R/+RW used.
Appears when a disc recorded in the
PAL system was loaded: This DVD video
camera/recorder is exclusively for the
NTSC system and does not comply with
the PAL system.
Appears when an unformatted or
logically damaged disc was loaded.
Also appears when a dirty disc was
loaded.
Appears if a battery is used when
fi nalizing a DVD-RW/DVD-R/+RW. The
specifi cations state that DVD-RW/DVD-
R/+RW can be fi nalized only when the
AC adapter/charger powers the DVD
video camera/recorder.
Appears if a battery is used when
repairing video fi les. The specifi cations
state that video fi les can be repaired only
when the AC adapter/charger powers the
DVD video camera/recorder.
Appears when an SD memory card
whose erasure prevention switch was
locked is loaded.
Appears if a disc that was write-
protected for disc units by software
disc-protect function is loaded, or if an
attempt is made to record on write-
protected disc.
4 - 11
Troubleshooting
Use the Disc Navigation function to
unlock the scenes, and then restart
operation.
Check the type of disc and insert a
disc usable on the DVD video
camera/recorder.
The disc does not need to be fi nalized:
Wait until the message disappears.
Use a disc recorded in the NTSC
system.
Format the disc (deleting all recorded
data), or replace the disc.
Refer to "4-3-5 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Terminate the Disc Navigation
function, set the power switch to
"OFF" with the disc loaded, remove
the battery, and then connect the AC
adapter/charger: Finalize the disc
again.
Set the power switch to "OFF" with
the disc loaded, remove the battery,
and then connect the AC adapter/
charger.
[Refer to *3 page 4-5]
Unlock the erasure prevention switch
of SD memory card.
Release the software disc-protect.