Setups For Adjustment; List Of Jigs And Tools For Adjustment; Test Equipment, Power Supply And Charts For Adjustment; Connections For Adjustment - Hitachi DZ-GX5020A K Service Manual

Adjustment > Setups for Adjustment

6-2 Setups for Adjustment

Restrictions:
Be sure to perform "6-1-1 Checking Reference Data" in advance.
No adjustment can be done without reference data.

6-2-1 List of Jigs and Tools for Adjustment

Same as when creating reference data: Refer to "6-1-2 List of jigs and tools when creating reference
data" for details.
1) Personal computer
2) Adjustment software
3) Halcyon connector
4) C12 light balance fi lter
5) DSP-R Jig
6) RS-232C cable
7) AV/S input/output cable
8) DZ-ACS3
9) Power cable
10) DC power cord

6-2-2 Test Equipment, Power Supply and Charts for Adjustment

1) Color bar chart
2) 3100 K light box (maintenance is necessary)
3) Backfocus chart
4) Color monitor (color TV with AV input jacks)
5) Oscilloscope
6) Vectorscope
7) Digital voltmeter
8) Frequency counter
9) DC power supply for DSP-R jig (5 V/1 A)
Information:
It is recommended that you use a vectorscope when
performing the chroma gain adjustment.
You can use an oscilloscope instead: Note, however, that
the adjustment accuracy will be lower.

6-2-3 Connections for Adjustment

Connect the DVD video camera/recorder, jigs and test equipment as shown in the Fig. 6-2-3.
Caution
It is very dangerous to perform any work with the DVD video camera/recorder disassembled, since
the DVD video camera/recorder has a laser-emitting block: Do not remove any parts other than the
adjustment cover.
Fig. 6-2-2 Backfocus Chart
6 - 12
Fig. 6-2-1 Color Bar Chart