Hitachi DZ-GX5020A K Service Manual page 93

Adjustment > Creating Reference Data
4) Choose the communication port to which the RS-232C
cable is connected, and then choose the radio button
of corresponding port on COMMUNICATION PORT
SETTING screen.
5) Click the OK button on the COMMUNICATION PORT
SETTING screen, and then proceed with the MODEL
SELECT screen.
Note:
If the following dialogs appear, perform the
troubleshooting below:
POWER OR CONNECTION ERROR dialog
ERROR
MAY OCCURE ON CABLE OR JIG OR CAMCORDER.
!
POWER FAILURE OR CONNECTION ERROR!
OK
COM PORT ERROR dialog
ERROR
!
COM PORT ERROR
OK
When the power or connection error dialog appears:
A connection is incorrect or power is not turned on.
Make sure that all connections are correct and that
power is supplied to the reference data creating
device or DSP-R interface jig.
Clicking the OK button will fi nish the software:
After solving the problem, restart the software.
When the communication port error dialog appears:
There was a mistake in selecting communication
port.
Check the communication port.
Clicking the OK button will fi nish the software:
Select the communication port again after restart.
COMMUNICATION PORT SETTING
screen
MANUAL ADJUSTMENT PROGRAM for SERVICE STATION
MANUAL ADJUSTMENT PROGRAM
4
5
6 - 8
for SERVICE STATION
COM PORT SETTING
PORT
PORT 1 PORT 4
PORT 2 PORT 5
PORT 3 PORT 6
EXIT
OK
Copyright (C) HITACHI, Ltd 2006