Engine (Gasoline) - Jacobsen 62287 Service Manual

ENGINE

Engine (Gasoline)

Removal and Installation
See Figure 3-44.
1. Park the mower safely. (See "Park Mower Safely" on
page 1-6.)
2. Allow the engine to cool completely before
attempting to service the engine.
3. Tag and disconnect the negative (–) battery cable.
4. Remove fuel tank. (See "Fuel Tank (Gasoline)" on
page 9-8.)
5. Remove fuel tank support pan. (See "Fuel Tank
Support Pan" on page 9-8.)
6. Remove muffler. (See "Muffler (Gasoline)" on
page 3-21.)
3
7. Remove gear pump. (See "Gear Pump" on
page 5-31.)
8. Disconnect the throttle cable and choke from the
engine.
NOTE
Label all wires before disconnecting to ensure correct
installation.
9. Tag and disconnect the wiring harness at the engine,
ignition modules, carb solenoid, starter motor, starter
solenoid, and engine oil pressure switch.
3-24
!
WARNING
Prevent personal injury. Use a properly rated
lifting device. Always be sure the load is
balanced before lifting.
1
2
6
5
Figure 3-44
10. Using the proper engine hoist, support the engine
and remove four nuts (5), lock washers (6), and
screws (2) securing the engine (1) to the engine
mount (4).
11. Move ground cable (3) aside.
12. Check for any connected wires and components, and
carefully remove the engine from the machine.
13. Place the engine on a suitable stand or workbench
that will support the full weight in a safe manner while
preventing damage to the engine.
NOTE
If the engine is being replaced, some components must
be removed and installed on the new engine. Refer to
"Parts and Maintenance Manual" for additional
information and illustrations.
3
4
TN3560
4247530-Rev A