Air Filter Assembly (Diesel); Throttle Cable (Diesel) - Jacobsen 62287 Service Manual

Air Filter Assembly (Diesel)

Removal and Installation
See Figures 3-12 and 3-13.
!
CAUTION
• Do not open the air filter assembly for
inspection or cleaning. Unnecessary removal
of the air filter increases the risk of injecting
dust and other impurities into the engine.
• Do not remove air filter with engine running.
NOTES
• The air filter on this engine is a dry type; never apply
oil to it.
• The dust cap should be removed and cleaned daily
in dusty conditions.
1. Park the mower safely. (See "Park Mower Safely" on
page 1-6.)
1
3
Figure 3-12
NOTE
To ensure correct installation, note the orientation of the
air inlet (3) before removing the air filter dust cap (2).
2. Release retaining clips (1) and remove the air filter
dust cap (2).
3. Using damp, lint-free cloths, thoroughly clean the
inside of the dust cap.
4247530-Rev A
4
4. Slide air filter (4) out of the assembly.
Installation Note
Install air filter assembly by reversing the order of
removal.

Throttle Cable (Diesel)

2
Removal and Installation
See Figures 3-14 and 3-15.
1. Park the mower safely. (See "Park Mower Safely" on
page 1-6.)
1
1
TN3328
2. Remove nut (3) from throttle linkage screw (2).
3. Remove nut (4), lock washer (5), flat washer (6), and
screw (7) from linkage bracket (8).
4. Remove throttle cable (1) from throttle linkage screw
(2).
ENGINE
Figure 3-13
2
8
3
4 5 6 7
Figure 3-14
3
TN3329
TN3330
3-11