Jacobsen 62287 Service Manual page 50

ENGINE
9
8
3
6. Remove two screws (2), two lock washers (3), and
two flat washers (4), and remove top radiator cover
bracket (9).
7. Remove two screws (5), two lock washers (6), and
two flat washers (7), and remove lower radiator cover
bracket (8).
10
23
19 20 21 22
24 25
8. Remove hose clamp (11) and recovery hose (10).
9. Remove hose clamp (18) and upper radiator hose
(12).
10. Remove hose clamp (24) and lower radiator hose
(25).
11. Remove two screws (19), lock washers (20), flat
washers (21), and nuts (22), and remove bracket
(23).
12. Remove two screws (13), lock washers (14), flat
washers (15), and nuts (16), and remove bracket
(17).
3-16
2 3 4
5
Figure 3-27
13 14 15 16
11
12
18
Figure 3-28
5
5
6 7
TN3371
13. Remove four screws (26), lock washers (27), and flat
washers (18), and move fan shroud (29) toward
engine enough to clear the radiator (5).
14. Remove radiator (5).
Installation
1. With the lower radiator hose removed from radiator,
flush the inside of the radiator with fresh water.
2. Install radiator by reversing the order of removal.
3. Fill the radiator with clean water and ethylene glycol
based antifreeze mixed for the coldest ambient
temperature.
4. Install radiator cap and start the engine following the
instructions in the "Safety and Operation Manual."
17
Allow the engine coolant to completely cool
before removing the radiator cap. Hot coolant
sprayed from the cap can cause serious personal
injury.
5. When the engine reaches normal operating
TN3372
temperature, check and fill the coolant reservoir to
the hot full level.
26 27 28
26 27 28
Figure 3-29
!
CAUTION
4247530-Rev A
29
TN3376