Oil Fill Assembly (Diesel) - Jacobsen 62287 Service Manual

ENGINE
3
9
5. Remove other end of throttle cable (1) from throttle
lever bracket (9).
Installation Notes
• Install throttle cable by reversing the order of
removal.
• Adjust throttle cable as needed. (See "Throttle Cable
Adjustment" on page 3-8.)

Oil Fill Assembly (Diesel)

Removal and Installation
See Figures 3-16 and 3-17.
1. Park the mower safely. (See "Park Mower Safely" on
page 1-6.)
Care must be taken not to drop anything into the
oil fill opening. Always cover the oil fill opening.
Leaving an opening uncovered may allow foreign
matter to fall into the engine; and cause severe
damage to the engine.
3-12
1
Figure 3-15
!
CAUTION
1
2. Remove oil fill cap (1) from the oil fill assembly.
TN3331
3. Loosen hose clamp (2) from the oil fill hose (4).
4. Remove two nuts (5) and remove the oil fill bracket
(6).
5. Remove hose clamp (3) and remove oil fill hose (4).
6. Unscrew and remove oil fill adapter (7) from the
engine.
Installation Note
Install oil fill assembly by reversing the order of removal.
2
6
4
5
Figure 3-16
7
Figure 3-17
4247530-Rev A
3
TN3342
TN2687