Jacobsen 62287 Service Manual page 53

Figure 3-33
11. Loosen hose clamp (6) and remove fuel line (5).
13
Figure 3-34
12. Remove gear pump (12). (See "Gear Pump" on
page 5-31.)
13. Remove anti-sway spring (11) from the center cutting
unit.
14. Remove nut (7), lock washer (8), screw (9), and plate
(10) from engine isolation mount (13).
4247530-Rev A
5
6
TN3377
7 8 9
10
11
12
TN3394
14
15
16 17
16 17
Figure 3-35
15. Remove two screws (16) and washers (17), and
remove fuel shutoff (14) and fuel shutoff bracket (15).
!
WARNING
Prevent personal injury. Use a properly rated
lifting device. Always be sure the load is
balanced before lifting.
23
20 21 22
Figure 3-36
16. Using a suitable engine hoist, support the engine and
remove nut (20), lock washer (21), and screw (22)
from engine isolation mount (23).
17. Remove two screws (18) and flat washers (19)
securing the engine mount to the frame.
18. Check for any connected wires and components, and
carefully remove the engine and engine mounts from
the machine.
ENGINE
TN3395
3
18 19
TN3398
3-19