Installing The Filter - Respironics REMstar Plus with C-Flex User Manual

Installing the Filter

CAUTION!
Power Cord
IMPORTANT!
WARNING!
WARNING!
CAUTION!
1. Install the filters and filter cap.
The foam filter must be in place at all times when the
REMstar Plus with C-Flex is operating. The white
ultra-fine filter is optional and can be used in
addition to the foam filter. The ultra-fine filter is
recommended for people who are sensitive to tobacco
smoke or other small particles.
a. Place one of the foam filters over the ultra-fine
filter. If you are not using the ultra-fine filter,
simply place the foam filter into the filter area on
the back of the REMstar Plus with C-Flex.
An extra filter is included for your convenience.
b. Attach the filter cap. Position the cap so that the small opening on the
cap is facing down. Insert the cap's tabs into the filter area opening.
2. Connect the power cord. Plug the socket end of
the power cord into the AC inlet on the back of
the REMstar Plus with C-Flex. Plug the pronged
end of the power cord into an electrical outlet.
To remove AC power, disconnect the power cord
from the electrical outlet.
Inspect the power cord often for any signs of
damage. Replace a damaged cord immediately.
The REMstar Plus with C-Flex is activated and ready for use when the
power cord is connected. The pressure start/stop button turns the
blower on/off.
3. Place the REMstar Plus with C-Flex on a firm,
flat surface.
Make sure the REMstar Plus with C-Flex is away
from any heating or cooling equipment (e.g., forced
air vents, radiators, air conditioners). Also make sure that bedding,
curtains, or other items are not blocking the filter or vents of the device.
Air must flow freely around the device for the system to work properly.
First Time Setup (cont.)
REMstar Plus with C-Flex User Manual
9