Routine Use; Connecting The Circuit; Adjusting The Circuit - Respironics REMstar Plus with C-Flex User Manual

Routine Use

Connecting
the Circuit
IMPORTANT!
Adjusting
the Circuit
1. Connect the circuit.
Before each use, examine the flexible tubing for any damage or
debris. If necessary, clean the tubing to remove the debris.
Replace any damaged tubing.
a. Connect the mask to the headgear, following the instructions
included with the headgear.
b. Put on the mask and headgear, and breathe normally through
your nose. The airflow should automatically start when you
begin breathing through the circuit. If the airflow does not start
within four breaths, press the pressure start/stop button on the
top of the REMstar Plus with C-Flex. When operating the
system with some mask types or some circuit configurations, the
airflow may NOT automatically start.
2. Adjust the circuit. Lie down on your bed, and adjust the flexible tubing
so it is free to move if you turn in your sleep. Adjust the mask and
headgear until you have a comfortable fit and there are no airflow leaks
into your eyes.
Pressure
Start/Stop
Button
REMstar Plus with C-Flex User Manual
17