Table of Contents
Advertisement
STARTING SYSTEM-Starter
Motor
8-101
Snap
L
Armature
1ELlO
pi-
SERVICE POINTS OF DISASSEMBLY
9. CAUTION
OF ARMATURE/ll.
BALL
When removing
the armature,
do not lose the ball which acts
as a bearing for the armature
and tip.
17. DISASSEMBLY
OF SNAP RING/18.
STOP RING
(1) Push the stop ring towards the snap ring using the proper
socket.
(2) After removal
of the snap ring with the snap ring pliers,
remove the stop ring and the over-running
clutch.
CLEANING
STARTER
MOTOR
PARTS
1, Do not immerse
parts in cleaning solvent.
Immersing
the yoke
and field coil assembly
and/or armature
will damage insulation.
Wipe these parts with a cloth only.
2. Do not immerse
drive unit in cleaning
solvent.
Overrunning
clutch is pre-lubricated
at the factory and solvent
will wash
lubrication
from clutch.
3. The drive unit may be cleaned with a brush moistened
with
cleaning solvent
and wiped dry with a cloth.
INSPECTION
CHECKING
COMMUTATOR
(1) Place the armature
on a pair of V blocks and check run-out with
a dial gauge.
Standard
value
: 0.05 mm (-0020 in.)
Limit
: 0.1 mm (.0039 in.)
wision
I
Advertisement
Table of Contents
