Receiver Drier, Condenser, Compressor Clutch Assembly - Mitsubishi Montero 1987 Service Manual

AIR-CONDITIONING
- Receiver drier, Condenser, Compressor Clutch
Assembly
24-45
RECEIVER DRIER, CONDESER, COMPRESSOR CLUTCH ASSEMBLY
REMOVAL AND INSTALLATION
N24TA--
Pre-removal Operation
l
Discharge the Refrigerant. (Refer to
P.24-36)
l
Remove the Radiator Grille. (Refer
to GROUP 23 BODY-Grille, Garnish,
Moulding)
l
Disconnect the Liquid Pipes and
Hoses.
Post-installation Operation
l
Install the Radiator Grille. (Refer to
GROUP 23 BODY-Grille, Garnish,
Moulding)
l
Charge the Refrigerant. (Refer to
P.24.37)
l
Adjustment of the Tension of the
Air Conditioner Drive Belt. (Refer to
P.24-40)
2OW832
Receiver drier removal steps
Compressor clutch assembly removal steps
1. Reveiver drier mounting bolt
8. Drive belt
2. Receiver drier
9. Compressor clutch assembly mounting
Condenser removal steps
3. Blower motor connector
4. Blower motor mounting bolt
5. Blower motor
6. Condenser mounting bolt
7. Condenser
bolt
10. Compressor clutch assembly
NOTE
Reverse the removal procedures to reinstall.
SERVICE POINTS OF REMOVAL
N24TBAB
1 STB Revision
Caution
If the hoses or pipes are disconnected,cap the hoses or pipes
with a blank plug to prevent entry of dust, dirt, and water.