Display Setup; Intelli-Time ® Clock; Set The Time, Date & Units - ACU-RITE 01033W Instruction Manual

Install or Replace Batteries
Display Unit
1. Slide off the battery compartment cover.
2. Insert 3 x AA alkaline batteries into the battery compartment, as shown.
Follow the polarity (+/-) diagram in the battery compartment.
3. Replace the battery
cover.
Intelli-Time
®
Intelli-Time products are pre-programmed with the correct time and date.
Intelli-Time technology instructs the time and date to set themselves. All you
need to do is select your Time Zone and Daylight Saving Time preferences. The
clock will then automatically set itself and change for Daylight Saving Time
Set the Time, Date & Units
Press and hold the "SET" button, located on the back of the display unit, to
enter SET MODE. Once in set mode, the preference you are currently setting
will blink on the display.
To adjust the currently selected (flashing) item, press and release the "+" or
" " buttons (press and HOLD to fast adjust).
To save your adjustments, press and release the "SET" button again to adjust
the next preference. The preference set order is as follows:
TIME ZONE ( PST MST CST EST AST HAST AKST)
DST (Daylight Saving Time ON or OFF)
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
TEMPERATURE SCALE (˚F or ˚C)
BAROMETRIC PRESSURE SCALE (inHg or hPa)
You will automatically exit SET MODE if no buttons are pressed for 30 seconds.
Enter setup mode at any time by pressing and holding the "SET" button.
Clock
6